88 CHAPTER 12: GARP&GVRP CONFIGURATION
[SW8800] gvrp
# Set Ethernet3/1/1 as a Trunk port and allows all the VLANs to pass through.
[SW8800] interface ethernet3/1/1
[3Com-Ethernet3/1/1] port link-type trunk
[3Com-Ethernet3/1/1] port trunk permit vlan all
# Enable GVRP on the Trunk port.
[3Com-Ethernet3/1/1] gvrp
Configure Switch B:
# Enable GVRP globally.
[SW8800] gvrp
# Set Ethernet4/1/1 as a Trunk port and allows all the VLANs to pass through.
[SW8800] interface ethernet4/1/1
[3Com-Ethernet4/1/1] port link-type trunk
[3Com-Ethernet4/1/1] port trunk permit vlan all
# Enable GVRP on the Trunk port.
[3Com-Ethernet4/1/1] gvrp
To Next Page
Loading...
