About This Manual
Organization
3Com AP9152 and AP9552 Access Points Quick Configuration Guide is organized as follows:
Chapter Contents
1 Logging In to the Web Interface Describes how to logging in to the web interface.
2 Setting IP Address Describes how to setting IP address.
3 WLAN Service Configuration
Describes the detailed configuration procedures
for wireless service configuration, access service
based VLAN configuration, PSK （WPA or
WPA2）authentication, local MAC authentication,
remote MAC authentication, remote 802.1X
authentication and 802.11n configuration.
4 WDS Configuration
Describes the detailed configuration procedures
for WDS and WDS point-to-multipoint.
5 Repeater Mode Configuration
Describes the detailed configuration procedures
for repeater mode.
6 Workgroup Bridge Mode Configuration Describes the detailed configuration procedures
for workgroup bridge mode.
7 Save Configuration over reboot Describes how to save configuration.
Conventions
The manual uses the following conventions:
GUI conventions
Convention Description
Boldface
Window names, button names, field names, and menu items are in
Boldface. For example, the New User window appears; click OK.
>
Multi-level menus are separated by angle brackets. For example, File >
Create > Folder.
Convention Description
< > Button names are inside angle brackets. For example, click <OK>.
[ ]
Window names, menu items, data table and field names are inside
square brackets. For example, pop up the [New User] window.
/
Multi-level menus are separated by forward slashes. For example,
[File/Create/Folder].
To Next Page
Loading...
Need help?
General
