3Com AP9552 User Manual

3-3
The IP addresses of clients obtained by the AP can be displayed only when ARP snooping is enabled.
By default, ARP snooping is enabled.
z The client can be pinged successfully on the AP.
guration guidelines Confi
Note the following when configuring a wireless service:
is enabled.
z Select a correct country/region code.
z Make sure that radio
z When satisfied with the configuration Save Configuration to File to ensure it is not lost when the
Access Point restarts.
Access Service Based VLAN Configuration Example
Network requirements
As shown in Figure 3-7, it is required to configure the AP to provide multiple wireless access services.
use different wireless security policies,
that and are bound to different VLANs to implement isolation
PSK authentication. Clients that
ear text authentication. Clients
iguration
between wireless access users. More specifically,
z Set up a wireless service named research, and configure it to use
access the WLAN are in VLAN 2.
z Set up a wireless service named office, and configure it to use cl
that access the WLAN are in VLAN 3.
Figure 3-7 Network diagram for access service-based VLAN conf
L2 switch
FAT AP
SSID
：
research
VLAN
：
2
Client 1
Client 2
IP network
SSID
：
office
VLAN
：
3
C
egion Code from the navigation tree to enter the page for setting a
n
onfiguration procedure
1) Select a correct country/region code
Select Advanced > Country/R
cou try/region code, as shown in Figure 3-2.
2) Configure a wireless service named research.
service.
e of the wireless service as research.
z Select the wireless service type crypto.
z Click Apply.
# Create a wireless
Select Wireless Service > Access Service from the navigation tree, and click Create to enter the page
for creating a wireless service.
z Configure the nam

3Com AP9552 Specifications

General

Brand	3Com
Model	AP9552
Category	Wireless Access Point
Language	English