3D Systems CubeX User Manual

3
Put the CubeX printer into manual move mode.
4
Raise the print pad until it is approximately 5mm away from the print tips.
5
Slowly raise the print pad until it lifts the new print tip in line with the others. All three print tips should be
touching the bed without putting any pressure on it.
6
Turn the CubeX printer off and unplug it from the mains power supply.
7
Using the 2.5mm hex driver, tighten the print tip holding bolt (pictured) to lock the print tip in place.

3D Systems CubeX Specifications

General

Printing colors	White
Print technology	-
Printing material	ABS, Polylactic acid (PLA)
Maximum build speed	15 mm³/s
Layer thickness (max)	0.100 mm
Layer thickness (min)	- mm
Number of print heads	1
Maximum build size (WxDxH)	275 x 265 x 240 mm
Product color	Gray
Viewing window	Yes
Maximum extruder tip temperature	280 °C
Ethernet LAN	No
AC input voltage	110-240 V

Weight and Dimensions

Width	515 mm
Height	598 mm
Weight	36000 g