3D Systems, Inc. p/n 77-D005 Rev_A
3 SAFETY GUIDELINES & INSTRUCTIONS
GENERAL GUIDELINES
Before using your SLS equipment, your company should have a safety program in place . The safety program should:
• Point out hazardous equipment, materials, and procedures.
• Explain what to do in case of an emergency.
• Provide information about the hazards of the equipment and materials in the form of Safety Data Sheets (SDS).
The Safety Data Sheets are provided with all materials supplied by 3D Systems.
All SLS equipment is designed with safety in mind . However, improper use, malfunctions, and excessive exposure could cause
injury .
TRAINING AND INSTRUCTIONS
Follow these general safety guidelines when operating any SLS equipment:
• Do not operate any SLS equipment before receiving proper training.
• Read and follow all operating instructions.
• Follow all safety rules in this section and heed all hazard warnings in this guide.
• Do not try to perform any equipment maintenance procedures you were not trained to do.
• Operators are trained to operate the system and perform all the necessary tasks to print a part.
To Next Page
Loading...
Need help?
General
