24
Figure 7-7 7000r-7000r3 Pro Frame Set-Up
7. Hold taping head BUFFING ROLLER and
cut and remove cable tie that holds applying/
buffi ng arms retracted (Applying/buffi ng rollers
are held retracted for shipment - See Figure 7-6).
Allow buffi ng/applying arms to extend slowly.
Also cut and remove cable tie at rear of lower
taping head.
8. Check for free action of both upper and lower
taping heads. Push buffi ng roller into head to
check for free, smooth action of taping heads.
9. Ensure that the tape drum bracket assembly,
located on the lower taping head, is mounted
straight down (Figure 7-8). The tape drum
bracket assembly can be pivoted to provide
tape roll clearance in certain cases.
Column Guards
Buffi ng
Roller
Cable
Tie
C
• To reduce the risk associated with
sharp blade hazards:
− Keep hands and fi ngers away from
tape cutoff blades under orange blade
guards. The blades are extremely sharp.
• To reduce the risk associated with
sharp blade hazards:
− Keep hands and fi ngers away from
tape cutoff blades under orange blade
guards. The blades are extremely sharp.
7000r-7000r3 Pro - NA
2014 June
7-INSTALLATION (continued)
WARNING
WARNING
Note:
Column Guards
are removed
before
Installing the
Bumper Supports .
Column Guards
are then reinstalled
(as shown in a rotated
180° position)
B
A
To Next Page
Loading...
