3M 6000 Series

To Next Page

To Previous Page

*AS/NZS 1715 Required Minimum Protection Factor

*ES = Exposure Standard

Gas/Vapour Filter Classes

The 6000 Series gas/vapour ¿lters are also classi¿ed, into one of two classes, depending on their capacity to remove

contaminants from the inhaled air

Filter Type

3M™ 6051/06911 A1

ABE1

ABEK1

A1 & formaldehyde

Combination organic vapours (b.pt >65°C (with good warning properties), inorganic gases, acid gases

Ammonia and Organic Ammonia derivatives (with good warning properties) as speci¿ed by the manufacturer

Organic Vapours with boiling point > 65°C (with good warning properties) as speci¿ed by the manufacturer

Organic Vapours with boiling point > 65°C (with good warning properties) as speci¿ed by the manufacturer &

formaldehyde up to 10 ppm

Combination organic vapours (b.pt >65°C (with good warning properties), inorganic gases, acid gases,

ammonia

3M™ 6055/ 06915

3M™ 6054

3M™ 6057

3M™ 6059

3M™ 6075

ClassiÀcation

Gas Filter Class Maximum use concentration with 3M™ Half mask

Maximum use concentration with 3M™ Full Face mask

Brown

Organic Vapours with boiling point > 65°C (with good warning properties) as speci¿ed by the manufacturer

Inorganic Gases & Vapours (with good warning properties) as speci¿ed by the manufacturer

Acid Gases (with good warning properties) as speci¿ed by the manufacturer

Ammonia and Organic Ammonia derivatives (with good warning properties) as speci¿ed by the manufacturer

Organic vapours with boiling point < 65°C (with good warning properties) as speci¿ed by the manufacturer

10 x ES* or 1000 ppm (0.1% vol) whichever is lower

Up to 50* x ES or 1000ppm (0.1% vol) whichever is lower.

Up to 100* x ES or 5000ppm (0.5% vol) whichever is lower.

10 x ES* or 1000 ppm (whichever is lower)

Formaldehyde vapour

Grey

Yellow

Green

Olive greenFormaldehyde

Brown

Type of Contaminant

APPROVALS

These products meet the requirements of the European Community Directive 89/686/EEC (Personal Protective Equipment Directive) and are thus CE

marked. Certi¿cation under Article 10, EC Type-Examination and Article 11, EC Quality Control, has been issued by BSI, Kitemark Court, Davy Avenue,

Knowlhill, Milton Keynes, MK5 8PP, UK (Noti¿ed body number 0086).

These respirators have been produced to comply with the requirements of the Australian/New Zealand Standard AS/NZS 1716:2012 under an agreed

production certi¿cation scheme operated during manufacture in accordance with the SAI Global StandardsMark programme.

Filter Type Colour Code

Type of Contaminant

Do not store outside the temperature range -10°C to +50°C or with humidity above 90%. When stored as stated, the expected shelf life of the 605X, 6075

and 609X products is 5 years from date of manufacture. End of shelf life (use-by) date is marked on the product and packaging. The original packaging is

suitable for transporting the product.

TECHNICAL SPECIFICATION

EN 14387:2004 + A1:2008 3M gas/vapour ¿lters generally protect against either single or multiple contaminant type(s) and against particulates when

combined with a particulate ¿lter.

:ϝϭΣ ΕΎϣϭϠόϣ ΩΟΗγ ΙϳΣ ϕΑρϣ ϭϫ Ύϣ ΏγΣΑ 3M TM ϝ 5000 ΔϠγϠγ ϊϣ ˬΎοϳ΃ϭ ΏγΎϧϣϟ΍ ϪΟϭϟ΍ ωΎϧϘϟ 3M TM ΕΎϣϳϠόΗ ϊϣ ΏϧΟ ϰϟ· ΎΑϧΟ ΕΎϣϳϠόΗϟ΍ ϩΫϫ Γ˯΍έϗ ϰΟέϳ

Ε΍έ΍ϭγγϛ· •

έΎϳϏ ϊρϗ •

3M TM έΗϼϓ ϭ 3M TMϪΟϭϟ΍ Δόϧϗ΃ ϥϣ ΓΩϣΗόϣ ΕΎϋϭϣΟϣ •

.1.ϝϛηϟ΍ έυϧ΃ ΕΎΣηέϣϟ΍ ΔϋϭϣΟϣϟ ΢ϣγϳ

ΞΘϨϤϟ΍ ΕΎϔλ΍Ϯϣ

EN 14387:2004 + A1:2008 :ΔϳϟΎΗϟ΍ ΔϳγΎϳϘϟ΍ ΕΎϔλ΍ϭϣϟ΍ ΕΎρ΍έΗη΍ ϲϓϭΗγϳ ΞΗϧϣϟ΍ ΍Ϋϫ

3M ΕΎϣϳγΟϟ΍ ΕΎΣηέϣ ϡ΍ΩΧΗγ΍ ϥϛϣϳ ˬϙϟΫ ϰϟ· ΔϓΎοϹΎΑϭ .(Δϳϧϔϟ΍ ΕΎϔλ΍ϭϣϟ΍ έυϧ΍) .έΎΧΑϟ΍ έρΎΧϣ νόΑϭ ίΎϐϟ΍ Ωο ΔϳΎϣΣϟ΍ ϰϠϋ ΩϋΎγϳ ˬϝϣΎϛ ϡΎυϧϛ Ϫϣ΍ΩΧΗγ· Ωϧϋ ΞΗϧϣϟ΍ ΍Ϋϫ

6000 ΔϠγϠγ 3M TM έΎΧΑϟ΍ ϭ ίΎϐϟ΍ ΕΎΣηέϣ ϊϣ ΏϧΟ ϰϟ· ΎΑϧΟ 5000 ΔϠγϠγ TM

ΩϮϴϗ ϭ Ε΍ήϳάΤΗ

.(ήϳΪΤΗ ΚϠΜϤΑ ΢οϮΗϭ) ΎϬϴϟ· έΎθϳ ΚϴΣ ,ήϳάΤΘϟ΍ Ε΍έΎΒόϟ ιΎΧ ϡΎϤΘϫ· ˯ϼϳ· ϲϐΒϨϳϭ

ϭ ΕΎϤϴϠόΘϟ΍ ϊϴϤΟ ωΎΒΗ΍ ϲϓ Ϟθϔϟ΍ ϱΩΆϳ Ϊϗ .΍ϮΟ ΔϟϮϤΤϣ ΔϨϴόϣ ΕΎΛϮϠϣ Ϧϣ ΎϬϳΪΗήϣ ΔϳΎϤΣ ϲϓ ΞΘϨϤϟ΍ ΪϋΎδϳ ϥ΃ ϞΟ΃ Ϧϣ Δϳέϭήο ΔΒγΎϨϤϟ΍ ΔϧΎϴμϟ΍ϭ ϡ΍ΪΨΘγϻ΍ϭ ˬΐϳέΪΘϟ΍ϭ ˬέΎϴΘΧϻ΍ ϦδΣ