Driver Installation Under FreeBSD
94 3ware 9000 Series Serial ATA RAID Controller Installation Guide
h Add the following line to “Makefile.i386’
CFLAGS+=-I/sys/dev/twa
i If you intend to bundle the firmware image with the driver,
add the following line to /sys/conf/options:
TWA_FIRMWARE_FLASH opt_twa.h
and the following line to your kernel configuration file
(“custom” in the example above):
options TWA_FLASH_FIRMWARE
j If you intend to enable printing of debug messages in the
driver, add the following line to /sys/conf/options:
TWA_DEBUG opt_twa.h
and the following line to your kernel configuration file
(“custom” in the example above):
options TWA_DEBUG=<number from 0 to 10>
Specifying 0 in the above line prints no debug messages,
whereas specifying 10 prints a LOT of debug messages.
5 Rebuild the kernel and install the new kernel.
6 Reboot with the rebuilt kernel.
Compiling the Driver as a Loadable
Module
If you wish to compile the driver yourself (for a different kernel
version that you are running), then perform the following steps.
1 Create the directories /sys/modules/twa and /sys/dev/twa
mkdir /sys/modules/twa
mkdir /sys/dev/twa
2 Copy the 3ware driver source file archive (twa.tgz) to
/sys/dev/twa.
To Next Page
Loading...
