Driver Installation Under Linux
www.3ware.com 41
Determining the Current Version of your 3ware Driver
If you already have a 3ware controller installed, you can check the current
driver version, using either 3DM 2 or the CLI. (For details, see “Viewing
Information About a Controller” on page 80.)
You can also check it using the following method:
If you have a 2.4 kernel or earlier,
type the following command:
cat /proc/scsi/3w-9xxx/*
where the asterisk (*) represents SCSI host ID and 9xxx represents the
family of the controller. For example:
cat /proc/scsi/3w-9xxx/0
If you have a 2.6 kernel with sysfs, type the following command:
cat /sys/class/scsi_host/<hostid>/stats
where <hostid> is usually host0, unless other SCSI devices are available,
in which case it may be host1 or higher.
If you have a 2.6 kernel without sysfs, type the following command:
dmesg | grep 3w
Driver Installation Under Red Hat Linux or
Fedora Core 5
Materials required
• 3ware software CD-ROM
• Floppy diskette, if you need to create a driver install diskette.
• Red Hat Linux installation DVD or CD-ROM. (Not required if Red Hat
Linux is already installed on another drive.)
Creating a Red Hat Linux Driver Diskette
If you are installing Linux on the new drive or unit managed by the 3ware
RAID controller, you must create a 3ware driver install diskette. If Linux is
already installed on another device, you may install the 3ware kernel driver
module from the 3ware software CD-ROM.
To create a Red Hat Linux driver install diskette
1 Insert the 3ware software CD into your system.
2 When the 3ware Escalade Menu appears, click the Driver & Firmware
Disks button.
To Next Page
Loading...