EasyManua.ls Logo

A.O. Smith BTH-120 - Start Up; Prior to Start Up; Filling and Gas Purging; Initial Start Up Procedure

A.O. Smith BTH-120
80 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
52
PRIOR TO START UP
         



        
   

         



       

         
        

       

         




FILLING THE WATER HEATER

 
 

 

 

SUPPLY GAS LINE PURGING
Fire or Explosion Hazard
Read instruction manual before
installing, using or servicing
water heater.
To avoid risk of fire or explosion purge discharge must not
enter into confined areas or spaces where ignition can occur.
The area must be well ventilated and all sources of ignition
must be deactivated or removed.
Gas line purging is required with new piping or systems in
which air has entered.
Use only the gas shown on the water heater rating label.
Keep ignition sources away from faucets after extended
periods of non-use.
 
 

           

 

INITIAL START UP
REQUIRED TEST EQUIPMENT
 

 



NOTE:        

PREPARATION
 
        

 
 
 
 


         
             






          
        


        





          
         
          
  
          

 
 
         


START UP

Table of Contents

Other manuals for A.O. Smith BTH-120

Related product manuals