Do not work in a closed area where
refrigerant or nitrogen gases may be
leaking. A sufficient quantity of vapors
may be present and cause injury or
death.
Door compartments containing
hazardous voltage or rotating parts
are equipped with door latches to
allow locks. Door latch are shipped
with nut and bolts requiring tooled
access. If you do not replace the
shipping hardware with a pad lock
always re-install the nut & bolt after
closing the door.
PVC (Polyvinyl Chloride) and CPVC
(Chlorinated Polyvinyl Chloride) are
vulnerable to attack by certain
chemicals. Polyester (POE) oils used
with R-410A and other refrigerants,
even in trace amounts, in a PVC or
CPVC piping system will result in
stress cracking of the piping and
fittings and complete piping system
failure.
Do not weld or cut foam panel with
plasma cutters or a cutting torch –
When burnt the foam produces
dangerous fumes.
Never attempt to open an access door
or remove a panel while the unit is
running. Pressure in the unit can
cause excessive force against the
panel.
Ensure that sufficient dampers will be
open to provide air path before fan is
allowed to run.
This appliance is not intended for use
by persons with reduced physical,
sensory or mental capabilities, or lack
of experience and knowledge, unless
they have been given supervision or
instruction concerning use of the
appliance by a person responsible for
their safety. Children must be
supervised to ensure they do not play
with this appliance.
In order to avoid a hazard due to
inadvertent resetting of the THERMAL
CUT-OUT, this appliance must not be
supplied through an external switching
device, such as a timer, or connected to a
circuit that is regularly switched on and
off by the utility.
To Next Page
Loading...
