Milan / Paylink System Manual Issue 1.5 29 January 2020
CONFIDENTIAL
Not to be disclosed without prior written permission from Aardvark Embedded Solutions Ltd
Page 18 of 71
Control of Motorised Acceptors
ccTalk bulk coin acceptor (1.11.3)
Paylink will automatically send the required command to operate the motor on a bulk coin acceptor,
but the application may want to trigger the special “reject clearance mode”. This is requested by
inhibiting all the coins for the acceptor, and inhibiting the acceptor itself. (To just stop accepting coins,
it is only necessary to inhibit the acceptor)
BCR / CR10x coin recyclers (1.11.5)
There are a number of features of these devices that require special handling by Paylink. Specifically
Paylink will:
o Issue a carousel clear to a CR10x 2 seconds after the unit is disabled, if a Payout has not
been requested.
o Respond to a BCR fault reports with a subsystem clear command
o Report the unit is busy while any of the carousel, singulator, payout belt etc. are active
To Next Page
Loading...