Milan / Paylink System Manual Issue 1.5 29 January 2020
CONFIDENTIAL
Not to be disclosed without prior written permission from Aardvark Embedded Solutions Ltd
Page 34 of 71
Cashcode B2B-60
The Cashcode B2B-60 operates by paying bills one at time for retrieval through the acceptor. To
allow for full control in the event of a power failure / connection problem, Paylink runs the acceptor so
that each note is a separate transaction. This interacts badly with coins if you set the simultaneous
hoppers flag.
Merkur 100
This recycler automatically restarts a payout on power up, unless a software reset is issued before
the acceptor reaches the point at which the delivery is under way.
During the startup process, Paylink issues such a reset, so if the two units power up approximately at
the same time, no spurious bill is paid. If this succeeds, then any bills “in progress” will be returned to
the stacker.
This recycler is capable of directing the same bill to multiple dispensers, using the method described
above.
To Next Page
Loading...