113MD Evolution – Dialog 4425 IP Vision
Call Forwarding Services
Call Press the dynamic function key shown on the left.
Your extension will sound the service acceptance tone, and then
return to the idle status, while the incoming call is deflected to the
recipient you have just programmed. It is then processed as a
normal call forward.
Notes:
The call deflection service may also be used when you have
an ongoing call, as long as your extension has at least one
free line key. The procedure is identical; your current call will
be immediately placed on hold, but only until the call deflec-
tion has been activated.
The ** <FWD NO> sequence may be saved on one of your
extension’s repertory keys, or one of the associated satellite
keys, as the case may dictate. Pressing this repertory key
would therefore replace the manual dialling of the sequence.
As an alternative to a call deflection, you may use the
dynamic “Reject” function offered when any type of
incoming call is presented. If your extension is set for the
call forward on no-answer condition, the calling party is
immediately forwarded to the call forward on no-answer
recipient. See the “Operations for Incoming Calls” section.
To Next Page
Loading...
Need help?
General