Installation Installing Interface Cards
33
■ The slots are not of the same type. Therefore some of the available interface
cards may not be operated in all slots. Note the overview under Interface Cards
starting on page 43.
OpenCom 130: Installing an interface card in an expansion module slot
Proceed as described below to install an interface card:
1. Turn off the OpenCom 100. Open the housing cover.
2. Remove the slot card from the transport packaging. Check that it is the correct
slot card type. There is a sticker with the type name on the connector.
CAUTION! Static charges can damage electronic compo-
nents. Pay attention to the regulations regarding
the handling of electrostatically sensitive compo-
nents.
3. Carefully insert the interface card in the slot provided. The component side
must face to the right.
Type (name) of
interface card
To Next Page
Loading...
