S
2M
Connector Module Installation
69
5.1 Installation
Please note: The module should only be installed by trained personnel.
DANGER! The device contains hazardous voltages.
1. Pull out the mains plug of the OpenCom 130 / 150.
2. Open the housing cover of the OpenCom 130 / 150.
3. On the module board, remove the protective covers of the two S
2M
slots (A)
and (B).
Position of the S
2M
slots on the module board
4. Insert the S
2M
module into the slots, making sure you insert the LED side of the
module into the upper slot (B).
LAN 1PCM LAN 2
Activity LED
B
A
S
2M
slots
To Next Page
Loading...
