Mounting the OpenCom 150 Rack InfoCom System Technical Data
73
6.2 Technical Data
(only if different from the OpenCom 150)
Dimensions:
■ Width: 19-inch panel with flange for mounting in installation cabinet
■ Height: 3U
■ Depth: approx. 340 mm
Weight:
approx. 7.8 kg
Connection of 230 VAC power supply on rear side via inlet connector for non-
heating apparatus
Connection of all ports via RJ 45 jacks on front panel
Note: The ISDN S
0
ports on the front panel may only be
switched in one direction (internal or external). Use of the ex-
ternal port with a crossover (Rx-Tx) patch cable in parallel to
the S
0
internal port (for two S
0
terminals on the same bus)
may severely limit the range of the S
0
bus.
To Next Page
Loading...
