Installation Installing the Memory Card
62
3.13.2 To Install a Memory Card …
1. Unplug the OpenCom 100.
2. Open the OpenCom 100 housing cover.
CAUTION! Make sure you protect yourself against electrostatic
discharge.
Static electricity can damage the memory card. To avoid such damage, the static
electricity must be earthed from your body. Work only in an anti-static envi-
ronment. If possible, use earthing underlays or anti-static mats.
3. Insert the memory card in the base on the upper edge of the module board.
Inserting a Compact Flash card
4. Replace the housing cover.
5. Insert the mains plug.
The OpenCom 100 is restarted. The configuration last loaded is reactivated.
COMPACT FLASH
To Next Page
Loading...
