Configuration Configuring the OpenCom 100
80
OpenCom 100 (this screenshot: OpenCom 150): log-on dialogue box
3. To commence configuration, you must first log on. For the initial configuration,
enter your:
user name: “Administrator”
password: for the initial configuration, leave this box blank.
4. Confirm this by clicking on OK. This puts all connected terminals into the
“Guest” user group with restricted user rights. In this way you prevent interna-
tional external calls from the terminals, for example, while you are configuring
the OpenCom 100 and the users.
OpenCom 100 (this screenshot: OpenCom 150): dialogue box for initial access
5. The software opens a dialogue for initial access. Determine an administrator
password and enter it in this dialogue. Also fill in the other input fields.
6. Confirm your input with Apply.
To Next Page
Loading...
