AAXA Technologies P6 ULTIMATE - AAXA P6 Ultimate: Getting Started; Powering On, Off, and Standby Modes

4 5
Getting Started
Chapter 2
Powering ON the projector
Powering OFF the projector
Standby Mode
1. To transition to “STANDBY” mode, press the power button on the remote control.
2. The optical engine should power o󰀨 and the fan should stop spinning. The projector
is now in “STANDBY” mode and can be turned on using the remote control.
*Note: Standby mode will still consume a small amount of power.
1. To turn o󰀨 the projector, toggle the “Power Switch” to the “OFF” position. This will
fully turn o󰀨 the projector. The unit can only charge when it is o󰀨.
1. The P6U should be fully charged before startup.
2. The P6U charges through the Type C power port found
under “Power Input” next to the carry handle.
3. Toggle the On / O󰀨 switch to “On” and the projector
should automatically turn on.