2.8.0 ERROR DISPLAY
The control unit is equipped with diagnostics
software. During normal operation, various
conditions are checked. As soon as an error
is detected, the control unit stops and all
operating symbols start flashing. For potential
error causes please refer to the table below.
ATTENTION!
Re-start only after switching off and
switching on again!
*
Contact service personnel!
WARNING!
If fault repairs necessary, disconnect all
poles of the supply line before opening the
housing!
3.0.0 IMPORTANT
INSTALLATION
INFORMATION
WARNING!
This instruction manual is supplied
together with the installation manual of
the sauna cabin! Follow all instructions
concerning the cabin construction.
WARNING!
The electrical connections of the control
unit must be exclusively carried out by
licensed specialists in accordance with
the provisions of the local power supply
companies. Use original parts only.
WARNING!
You should use a sauna heater that
conforms to the following standards:
EN60335-1 and EN60335-2-53.
WARNING!
Please note that the EN60335-2-53
standard, table 101, provides for a
maximum heater output dependent on
room size.
The control unit must be connected in strict
compliance with these instructions! Only use
the supplied original cables and original
parts! We refuse to accept any responsibility
for damage or consequential damage caused
by any parts supplied by other manufacturers
or parts that have been incorrectly
connected.
Check all cables for damage. Even cables
with minor damage (e.g. squashing, etc.) are
dangerous! Have such cables exchanged by
service personnel immediately!
We refuse to accept any responsibility for
damage or consequential damage caused by
any damaged parts.
To Next Page
Loading...
Need help?
General