266CRx, 266JRx, 266CSx, 266JSx | OI/266CXX/266JXX/HART-EN Rev. B 49
MV Setup - closed Tank MV-Calculation No Calculation
Flow
Level
Level Calculation
Level Unit Steam Drum Level
Open Tank
Closed Tank
Closed Tank, 2 Remote
Seals
Lower Level Dimension b from Fig. 34
Upper Level Dimension d from Fig. 34
Distance process
Connection
Dimension e from Fig. 34
Transm. mount. Pos. Dimension a from Fig. 34
Temperature Unit
Min. Temperature Minimum measuring medium temperature
Max. Temperature Maximum measuring medium temperature
Density Unit
Min. Temp. Density Density of the measuring medium at minimum temperature
Max. Temp. Density Density of the measuring medium at maximum temperature
Temperature Gas Density Reference temperature for specification of the gas density, e.g.
0 C for “standard conditions”.
Static Pressure Unit
Pressure Gas Density Reference pressure for specification of gas density, e.g 1.013
bar for “standard conditions”
Gas Density Gas density for the reference conditions specified above
Tube Temperature PT100
Sensor Temperature
Fixed Value
Value Condensate
Temperature
Restore Last Parameter
Fig. 34: Diagram - “Level measurement - closed tank”
H1 The lower fill level to be measured | H2 The higher fill level to be measured
1 Fill level | 2 Pressure transmitter | 3 Low pressure impulse line | 4 High pressure impulse line | 5 Gas above the liquid line
To Next Page
Loading...
