ABB 2600T Series Operating Instruction

62 OI/266CXX/266JXX/HART-EN Rev. B | 266CRx, 266JRx, 266CSx, 266JSx
12 Error messages
12.1 Error states and alarms
Error code Displayed message Possible cause Recommended measure Transmitter
reaction
C042.046 Default Value as Process
Value
Substitute value for differential pressure active. The calculation will be executed with the
substitute value for differential pressure.
None
The last valid value for differential pressure
active.
The calculation will be executed with the
last valid value for differential pressure.
The calculation will be executed with the
substitute value for absolute pressure.
The calculation will be executed with the
substitute value for absolute pressure.
Last valid value for absolute pressure active. The calculation will be executed with the
last valid value for absolute pressure.
The calculation will be executed with the
substitute value for process temperature.
The calculation will be executed with the
substitute value for process temperature.
Last valid value for process temperature
active.
The calculation will be executed with the
last valid value for process temperature.
Substitute value for line temperature active. The calculation will be executed with the
substitute value for line temperature.
Last valid value for line temperature active. The calculation will be executed with the
last valid value for line temperature.
C056.047 Wrong Process Condition
for Flow
Wrong direction for root calculation. Check process connections for the flow
measurement in one direction.
None
Wrong aggregate status of the measuring
medium.
Check the aggregate status of the
measuring medium.
C088.030
Input Simulation Active The P-dP-value generated on the output is
derived from the value simulated on the input.
Use HART configurator (DTM – handheld
terminal) to switch the device back into the
normal mode (end input simulation).
None
The static pressure value generated on the
output is derived from the value simulated on
the input.
The sensor temperature value generated on
the output is derived from the value simulated
on the input.
C090.033
Loop Test The analog outputs and digital /analog outputs
for the primary variable are held at the desired
value. The device is in fixed current mode
(loop test).
Use HART configurator (DTM – handheld
terminal) to switch the device back into the
normal mode (loop test - end fixed output
mode).
None

ABB 2600T Series Specifications

General

Brand	ABB
Model	2600T Series
Category	Transmitter
Language	English