ABB 2600T Series User Manual (English)

Other manuals for ABB 2600T Series

Instruction Manual136 pages

Operating Instruction84 pages

Operating Instructions96 pages

Instructions For Installation And Commissioning24 pages

Instructions For Installation20 pages

Questions and Answers:

T
Tony HutchinsonAug 2, 2025
What to do if ABB Transmitter detects an overpressure?
- V
  Victoria WarrenAug 2, 2025
  If the ABB Transmitter detects an overpressure because the measured process pressure value is outside the sensor limits and no longer represents the true applied process value, adjust the working range if possible.
N
Nancy JohnsonAug 7, 2025
What to do if ABB 2600T shows a pressure overrange?
- S
  Shelly SmithAug 7, 2025
  If the ABB Transmitter indicates a pressure overrange because the measured static pressure is above its operational limit, adjust the working range if possible.
J
Jennifer TaylorAug 12, 2025
How to execute replacement operation on ABB 2600T after changing electronics or sensor?
- M
  Michael CooperAug 12, 2025
  If the electronics or the sensor of your ABB Transmitter have been changed but the replacement operation has not been executed, you must perform the following steps: 1. Move the SW 1 of the electronics to position 1 to enable replace mode. 2. Select the SW 2 to indicate whether the new element is a new sensor or new electronics. 3. Power cycle the device. 4. Move the SW 1 of the electronics to position 0.
K
Kristi QuinnAug 17, 2025
What to do if ABB Transmitter sensor temperature is out of operational limits?
- H
  huntchristopherAug 17, 2025
  If the ABB Transmitter's measured sensor temperature is outside of its operational limits, check the valves and impulse line. If necessary, clean the impulse line and initiate PILD training.
D
Daniel WilliamsAug 22, 2025
What happens if ABB Transmitter device data is corrupted at start up?
- M
  Megan GreenAug 22, 2025
  If the device data loaded at the start up of your ABB Transmitter are corrupted, precluding the correct functionality of the device because of exchange of data problems between Electronics and Sensor, the device will continue to work without problems, but at the next power cycle the new configuration will be lost.

ABB 2600T Series Specifications

General

Output Signal	4-20 mA HART, Fieldbus
Response Time	< 100 ms
Process Temperature	-40 to 120 °C (-40 to 248 °F) (depending on model and fill fluid)
Ambient Temperature	-40 to 85 °C (-40 to 185 °F)
Power Supply	10.5 to 42 V DC (depending on communication protocol and options)
Housing Material	Aluminum or stainless steel
Material	Stainless steel, Hastelloy
Protection Class	IP66, IP67
Hazardous Area Approvals	ATEX, IECEx, FM, CSA
Process Connection	1/2" NPT, 1/4" NPT
Electrical Connection	1/2" NPT, M20
Operating Temperature	-40 to 85 °C (-40 to 185 °F)
Communication Protocol	HART, PROFIBUS PA, FOUNDATION Fieldbus