ABB AC 800M

About This Book Related Documentation
3BSE 027 941 R301 17
The applied standard is UL508, Industrial Control Equipment. Units approved for
use at hazardous locations also comply with the standard UL1604. To fulfill the UL
requirements for hazardous locations, the instructions in Appendix E, Standards
must be followed.
Related Documentation
Table 2 on page 17 details the documentation and media applicable to the AC 800M
Controller. Table 3 on page 19 details the media associated with the AC 800M
Controller.
Table 2. Related Documentation
Category Title Description
Hardware S800 I/O General
Information and
Installation
User’s Guide
Describes the general installation and
configuration for S800 I/O.
S800 I/O Units and
Termination Units
User’s Guide
Describes the standard I/O units and
termination units for S800 I/O.
S800 I/O Units and
Termination Units, with
Intrinsic Safety Interface
User’s Guide
Describes I/O units and termination units
with I.S. interface within S800 I/O.
S800 I/O Fieldbus
Communication,
Interface for
PROFIBUS DP
User’s Guide
Describes the PROFIBUS DP FCI within
the S800 I/O system.
AC 800M/C
PROFIBUS DP User’s
Guide Wiring and
Installation
Describes how to install and wire a
PROFIBUS DP I/O System.