ABB ACH550 series - Embedded Fieldbus and Fieldbus Adapters

64 E-Clipse Bypass Configurations for ACH550 Drives
Parameter Descriptions
Group 51
Code Name Resolution Range Default Description
5128 FBA PAR 28 1 0 - 0xFFFF 0 Parameter table version
5129 FBA PAR 29 1 0 - 0xFFFF 0 Bypass type code
5130 FBA PAR 30 1 0 - 0xFFFF 0 Mapping file version
5131 FBA STATUS 1 0 - 6 0 Fieldbus adapter status
5132 FBA PAR 32 1 0 - 0xFFFF 0 Module common software
version
5133 FBA PAR 33 0 - 0xFFFF 0 Module application software
version
Group 53
Code Name Resolution Range Default Description
5301 DV PROT ID hex 0x0000 - 0xFFFF 0x0000 All of drive's Group 53 must be
replicated on bypass, since drive
is configured for Modbus. All
Group 53 functionality associated
with selection by 98.02 shall be
hosted on bypass controller for
drive. Similar parameters shall
be allocated for bypass.
5302 DV MAC ID 1 0 - 65535 1 Drive station ID (NODE
ADDRESS)
5303 BAUD RATE 0.1 kbit/s 1.2, 2.4, 4.8, 9.6, 19.2,
38.4, 57.6, 76.8
9.6
5304 EFB PARITY 1 0=8 NONE 1,
1=8 NONE 2,
2=8 EVEN 1,
3=8 ODD 1
0
5305 PROFILE 1 0=ABB DRV LIM,
1=DCU PROFILE,
2=ABB DRV FULL
—
5306 DV OK MSG 1 0 - 65535 0
5307 DV CRC ERR 1 0 - 65535 0
5308 UART
ERROR
1 0 - 65535 0
5309 DV STATUS 1 0=IDLE,
1=EXECUT INIT,
2=TIME OUT,
3=CONFIG ERR,
4=OFF-LINE,
5=ON-LINE,
6=RESET,
7=LISTEN ONLY
0
5310
...
5318
DV PAR 10
...
DV PAR 18
1 0 - 65535 0