ACH580 Installation, Operation and Maintenance Manual 11
ACH580-01 Installation
3. Install the drive
Installing the drive vertically, frames R1…R4
The figures show frame R3 as an example.
1. Mark the hole locations using the mounting template included in the package. Do not
leave the mounting template under the drive. The drive dimensions and hole
locations are also shown in the drawings in the
ACH580 Hardware manual,
publication number 3AXD50000044839.
2. Drill the mounting holes.
3. Insert anchors or plugs into the holes and start the bolts into the anchors or plugs.
Use long enough bolts to make them carry the weight of the drive.
4. Position the drive onto the bolts on the wall.
5. Tighten the bolts in the wall securely.
Install the cable box, frames R1…R2
6. Remove the screw (6a) and lift the cover off (6b) from the separate cable box.
7. Attach the cable box cover to the front cover.
R1 R2 R3 R4
in. mm in. mm in. mm in. mm
a 3.86 98 3.86 98 6.30 160 6.30 160
b 12.48 317 16.42 417 18.62 473 24.37 619
Weight
IP21 (UL (NEMA)
Type 1)
lb kg lb kg lb kg lb kg
10.1 4.6 14.6 6.6 26.0 11.8 41.9 19.0
Weight
IP55
(UL (NEMA)
Type 12)
lb kg lb kg lb kg lb kg
10.6 4.8 15.0 6.8 28.7 13.0 44.1 20.0
1 2
3
×4
×4
R1…R2: M5 (#10)
R3…R4: M6 (1/4 in)
×4
4a
5
4b
×4
ACH580_Inst_Op_Maint_Rev G.book Page 11
To Next Page
Loading...
