10 ACH580 E-Clipse bypass and packaged drive user manual
Installation
Connection and wiring diagrams – Box E-Clipse Bypass
ACH580 Box E-Clipse Bypass units are configured for wiring access from the top
(for UL (NEMA) Type 1 and 12) and from the bottom (for UL (NEMA) Type 3R). The
following figures show the layout and wiring connection points. For drive control
wiring, see page 52. Maintain appropriate separation of control and power wires.
ACH580 Drive
Motor
Input Terminals
Motor Ground
Terminals
Disconnect Switch
or Circuit Breaker
B1
Service Switch
(Optional)
E-Clipse Bypass
Control Board
Terminals (X2)
User Power
Cable Guides
Input Ground
Lug
Lug
Fuses
(Bx1-1, Bx12-1)
MOV and
Line Reactor
(Optional)
To Next Page
Loading...
