ABB ACS560 - Page 104

DefaultUnitRange/ListNameIndex
Set2 output
min[1]
-None[0], Set2 output
min[1], other...
Set 1 PID output min source41.80
Set2 output
max[1]
-None[0], Set2 output
max[1], other...
Set 1 PID output max source41.81
1.00-See parameter 40.89
Set 1 setpoint multipli-
er
Set 2 setpoint multiplier41.89
1.00-See parameter 40.90
Set 1 feedback multipli-
er
Set 2 feedback multiplier41.90
43 Brake chopper
This parameter group is applicable only for frames R0...R3.
-%0.0 … 120.0Braking resistor temperat-
ure
43.01
Disabled[0]-0...3Brake chopper function43.06
Overvoltage peak
protection[3]
Enabled without
thermal model[2]
Enabled with
thermal model[1]
Disabled[0]
On[1]-Off[0], On[1], Other...Brake chopper run enable43.07
0s0…10000Brake resistor thermal tc43.08
0.00kW0.00 … 10000.00Brake resistor Pmax cont43.09
0.0ohm0.0 … 1000.0Brake resistance43.10
105%0…150Brake resistor fault limit43.11
95%0…150Brake resistor warning limit43.12
44 Mechanical brake control
0b0000-0b0000…0b1111Brake control status44.01
Not selected[0]-0...7, 18...20, 24...26Brake control enable44.06
Supervision
2[25]
Timed function
2[19]
DI5[6]DI2[3]Not selec-
ted[0]
Supervision
3[26]
Timed function
3[20]
DI6[7]DI3[4]Selected[1]
Other...Supervision
1[24]
Timed function
[18]
DI4[5]DI1[2]
0.00s0.00 … 5.00Brake open delay44.08
104 Parameter listing
EN
HI