ABB ACS560 - Start-Up and Use; Before You Start

ActionFrames
2b
2a
1a
1b
1b
1. Install the side plates (1a) of the cable box. Tighten the retaining screws
(1b) with a screw driver.
2. Slide the cover (2a) of the cable box on the module from below until the
cover snaps into place.
3. Reinstall the module cover (3a). Tighten the two retaining screws (3b)
with a screwdriver.
R6...R8
1a
1b
2a
3a
3b
Start up and use
This section describes how to install and start-up the drive using the basic control
panel.
Only limited information may be available in this manual. For detailed information
of all Menus and Sub menus, see the ACS-BP-S basic control panel user manual
(3AXD50000032527 [English]).
￭
Before you start
Make sure that the drive is installed as described in section Install the
drive (page 5).
34 EN - Quick installation and start-up guide
EN
HI