￭
Reinstalling side plates and covers, frames size R5…R8
1. Reinstall the module cover. Put the tabs on the cover top in their counterparts
on the housing and then press the cover.
2. Tighten the two retaining screws with a screwdriver.
If cable conduit box is used, perform the following:
ActionFrames
1. Slide the cover upwards (1a) and tighten the retaining screws (1b).
2. Reinstall the module cover (2a) and press the cover at bottom. Tighten
the two retaining screws (2b) with a screwdriver.
R5
EN - Quick installation and start-up guide 33
EN
HI
To Next Page
Loading...
