ABB ACS560 - Fault Messages

Fault messages
What to doCauseFault / Aux.
code aux code
visible only on
assistant con-
trol panel and
drive com-
poser))
Code
(hex)
Request backup or restore again.During backup/restore,
communication is lost
between panel/PC tool
and drive.
Backup/Restore
timeout
1080
Reset the fault or cycle the power
to the drive.
If the fault persists, contact your
local ABB representative.
Drive software is not able
to read the drive rating ID.
Rating ID fault1081
Try performing the current calibra-
tion again.
If the fault persists, contact your
local ABB representative.
Measured offset of output
phase current measure-
ment or difference
between output phase U2
and W2 current measure-
ment is too great (the val-
ues are updated during
current calibration).
Calibration2281
Diagnostics 153
EN
HI