ABB ACS560 - Page 183

PE
2b
3. :
If the power cable is temporarily removed from the grounding shelf, connect the
motor and input power cables except the 360° grounding, and then reinstall the
grounding shelf.
• Ground the shield 360° by tightening the clamp of the power cable grounding
shelf onto the stripped part of the cable (4a).
• (4b) 
• T1/U, T2/V T3/W 
• :
R4R3
lbf·ftN·mlbf·ftN·m
3.04.01.8…3.32.5…4.5T1/U. T2/V. T3/W.
4a
4b
4c
:
• -
• After reinstalling the grounding shelf, you can make the 360° grounding for
the cables.

4. 
[ Translation missing] The bare shield is grounded 360°. Mark the
pigtail made from the shield as a PE conductor with yellow-and-green color.
HI -   -  183
EN
HI