ABB ACS560 - Page 187


6. 
7. Prepare the ends of the input power cable and motor cable as illustrated in the
figure. If you use aluminum cables, put grease on the peeled aluminum cable before
connecting it to the drive. Two different motor cable types are shown in the figures
(7a, 7b).
[ Translation missing] The bare shield is grounded 360°. Mark the
pigtail made from the shield as a PE conductor with yellow-and-green color.
PE
7a
6
7a
7b
PE
7b
8. -()
9. :
• Ground the shield 360° under the grounding clamps.
• (9a) 
• T1/U, T2/V T3/W (9b) 
R8:
• ,
• ,
HI -   -  187
EN
HI