ABB ACS560 - Page 193

,
ACS560-01 :
• CMOD-02 power extension module (for R3...R5 frames)
• BAPO-01 power extension module (for R0...R2 frames)
• BIO-01 I/O (R0...R2 frames )
• Fieldbus module (in frames R0...R2 frames, fieldbus module can be used with
BIO-01 also)
,ACS560 
For more information on optional modules, see hardware manual.
￭
  

The BIO-01 front option module (Option +L515) is an I/O extension module for
R0...R2 frames and can also be used with any of the fieldbus optional module. The
BIO-01 I/O extension module provides:
• (DI3, DI4, DI5)
• (AI1), 
• 1 (DO1)
The digital output (DO1) is referred as DIO1 in the firmware. This works only in
output mode. You can also use DI4 and DI5 as frequency inputs and DO1 as a
frequency output.
BIO-01 

1
3
2
4
1. Locking tab
2. Fieldbus option module slot
3. Chassis screw
4. I/O connector
HI -   -  193
EN
HI