ABB ACS560 - Page 29

2. Remove the existing RIIO-01 module. To remove,
Note: The RIIO-01 module is available by default in standard ACS560-01 R0...R2
drives.
a. Loosen the locking screw.
b. Pull the locking tab out and unlock the RIIO-01 module.
a
b
c. Pull the module and remove it.
Note: The module can be tightly in position.
3. Align the BIO-01 module with the option module slot in the front of the drive.
4. Push the BIO-01 option module into position.
EN - Quick installation and start-up guide 29
EN
HI