/ ()(hex)
Make sure the prerequisites of the
autotune run are fulfilled.
The drive was started but
was not ready to follow the
autotune command.
0001
See section Before activating the
autotune routine (page 46) in
firmware manual.
Decrease torque step (parameter
25.38) or increase speed step (25.39).
Required torque reference
could not be reached before
the drive reached maximum
speed.
0002
Increase torque step (parameter
25.38) or decrease speed step (25.39).
Motor could not
accelerate/decelerate to
maximum/minimum speed.
0003
Decrease torque step (parameter
25.38) or speed step (25.39).
Motor could not decelerate
with full autotune torque.
0005
AFAA
(off2) (off2)AFE1
(off1 off3) (off1 off3)AFE2
AFE9
AFF5
20.12 1 AFEB
24 V DC ,95.0495.04 24V AFEC
()20.22120 AFED
ID AFF6
B5F6
STO STO B5A0
PFC ,:76.81 ... 76.84,PFC
PFC PFC D501
PFC ,76.81 ... 76.84PFC D502
76.81 ... 76.84()VSD PFC D503
STo FA90
296
EN
HI