Technical data
123
Materials
Drive enclosure • PC/ABS 2.5 mm, colour NCS 1502-Y (RAL 90021 / PMS 420 C)
• hot-dip zinc coated steel sheet 1.5 to 2.5 mm, thickness of coating 100 micrometers,
colour NCS 1502-Y
Package Plywood and cardboard. Foam cushions PP-E, bands PP.
Disposal The drive contains raw materials that should be recycled to preserve energy and natural
resources. The package materials are environmentally compatible and recyclable. All
metal parts can be recycled. The plastic parts can either be recycled or burned under
controlled circumstances, according to local regulations. Most recyclable parts are marked
with recycling marks.
If recycling is not feasible, all parts excluding electrolytic capacitors and printed circuit
boards can be landfilled. The DC capacitors (C1-1 to C1-x) contain electrolyte and the
printed circuit boards contain lead, both of which are classified as hazardous waste within
the EU. They must be removed and handled according to local regulations.
For further information on environmental aspects and more detailed recycling instructions,
please contact your local ABB distributor.
Applicable standards
The drive complies with the following standards. The compliance with the European Low
Voltage Directive is verified according to standards EN 61800-5-1 and EN 60204-1.
EN 61800-5-1:2003 Adjustable speed electrical power drive systems. Part 5-1: Safety requirements –
electrical, thermal and energy
EN 60204-1:2006 Safety of machinery. Electrical equipment of machines. Part 1: General requirements.
Provisions for compliance: The final assembler of the machine is responsible for installing
- emergency-stop device
- supply disconnecting device
- drive module into a cabinet.
EN 60529:1992 (IEC 60529) Degrees of protection provided by enclosures (IP code)
IEC 60664-1:2007 Insulation coordination for equipment within low-voltage systems. Part 1: Principles,
requirements and tests.
EN 61800-3:2004 Adjustable speed electrical power drive systems. Part 3: EMC requirements and specific
test methods
EN 61800-5-2:2007 Adjustable speed electrical power drive systems. Part 5-2: Safety requirements –
Functional
UL 508C (2002) UL Standard for Safety, Power Conversion Equipment, second edition
CSA C22.2 No. 14-05 Industrial control equipment
To Next Page
Loading...
