Introduction to the manual
22
Planning the electrical installation instructs in the motor and cable selection,
protections and cable routing.
Electrical installation instructs in how to wire the drive.
Installation checklist contains lists for checking the mechanical and electrical
installation of the drive.
Start-up describes the start-up procedure of the drive.
Fault tracing describes the fault tracing of the drive.
Maintenance contains preventive maintenance instructions.
Technical data contains the technical specifications of the drive module eg, the
ratings, sizes and technical requirements, provisions for fulfilling the requirements for
CE and other markings.
Dimension drawings contains dimension drawings of the drive modules and auxiliary
components.
Example circuit diagram shows an example circuit diagram for a cabinet-installed
drive module.
Resistor braking to select, protect and wire brake resistors.
Du/dt filters and sine filters describes how to select du/dt filters for the drive.
Categorization by option code
The instructions and technical data which concern only certain optional selections
are marked with option codes eg, +E210. The options included in the drive can be
identified from the option codes visible on the type designation label. The option
selections are listed in section Type designation key on page 32.
Quick installation, commissioning and operating flowchart
Task See
Plan the electrical installation.
Check the ambient conditions, ratings, required
cooling air flow, input power connection, compatibility
of the motor, motor connection, and other technical
data.
Select the cables.
Planning the cabinet installation (page 35)
Planning the electrical installation (page 57)
Technical data (page 111)
Resistor braking (page 137)
Option manual (if optional equipment is
included)
To Next Page
Loading...
