Electrical installation
93
Connecting a PC
Connect the PC to terminal X7 on the control unit.
Installing optional modules
Mechanical installation
Optional modules such as a fieldbus adapters, an I/O extensions and the pulse
encoder interfaces are inserted in the optional module slot on the control unit. See
page 30 for the available slots.
• Remove the cover assembly (if present) from on the control unit (refer to page
83).
• Remove the protective cover (if present) from the connector of the slot.
• Insert the module carefully into its position on the control unit.
• Fasten the screw.
Note: Correct installation of the screw is essential for fulfilling the EMC requirements
and for proper operation of the module.
Wiring the modules
See the appropriate optional module manual for specific installation and wiring
instructions. See page 92 for routing the cables.
To Next Page
Loading...
