ABB ACS880-17 - Page 283

Parameters 283
Current 01.07 Motor current (page 117). 4
Torque 01.10 Motor torque (page 117 ). 6
DC voltage 01.11 DC voltage (page 117). 7
Output power 01.14 Output power (page 118). 8
AI1 12.11 AI1 actual value (page 160). 9
AI2 12.21 AI2 actual value (page 162). 10
Speed ref ramp in 23.01 Speed ref ramp input (page 220). 18
Speed ref ramp out 23.02 Speed ref ramp output (page 220). 19
Speed ref used 24.01 Used speed reference (page 226). 20
Torque ref used 26.02 Torque reference used (page 242). 21
Freq ref used 28.02 Frequency ref ramp output (page 250). 22
Process PID output 40.01 Process PID output actual (page 311). 24
Process PID
feedback
40.02 Process PID feedback actual (page 311). 25
Other Source selection (see Terms and abbreviations on page 114). -
32.08 Supervision 1 filter
time
Defines a filter time constant for the signal monitored by signal
supervision 1.
0.000 s
0.000 … 30.000 s Signal filter time. 1000 = 1 s
32.09 Supervision 1 low Defines the lower limit for signal supervision 1. 0.00
-21474830.00 …
21474830.00
Low limit. -
32.10 Supervision 1 high Defines the upper limit for signal supervision 1. 0.00
-21474830.00 …
21474830.00
Upper limit. -
32.15 Supervision 2
function
Selects the mode of signal supervision function 2. Determines
how the monitored signal (see parameter 32.17) is compared
to its lower and upper limits (32.19 and 32.20 respectively).
The action to be taken when the condition is fulfilled is
selected by 32.16.
Disabled
Disabled Signal supervision 2 not in use. 0
Low Action is taken whenever the signal falls below its lower limit. 1
High Action is taken whenever the signal rises above its upper limit. 2
Abs low Action is taken whenever the absolute value of the signal falls
below its (absolute) lower limit.
3
Abs high Action is taken whenever the absolute value of the signal rises
above its (absolute) upper limit.
4
Both Action is taken whenever the signal falls below its low limit or
rises above its high limit.
5
Abs both Action is taken whenever the absolute value of the signal falls
below its (absolute) low limit or rises above its (absolute) high
limit.
6
32.16 Supervision 2
action
Selects the action the drive takes when the value monitored
by signal supervision 2 exceeds its limits.
Note: This parameter does not affect the status indicated by
32.01 Supervision status.
No action
No action No action taken. 0
No. Name/Value Description Def/FbEq16