2TLC172271M0201 Rev.H 5
1 Introduction
Scope
The purpose of these instructions is to describe the non-contact coded digital safety sensor Eden
DYN and to provide the necessary information required for installation and operation.
Audience
This document is intended for authorized installation personnel.
Prerequisites
It is assumed that the reader of this document has knowledge of the following:
• Basic knowledge of ABB safety products.
• Knowledge of machine safety.
Special notes
Pay attention to special notes in the document:
severe personal injury!
An instruction or procedure which, if not carried out correctly, may result in injury to the
technician or other personnel.
Risk of damage to the equipment!
An instruction or procedure which, if not carried out
correctly, may damage the
Important or explanatory information.
To Next Page
Loading...
Need help?
General
