ABB AMA - Default Chapter; Table of Contents

Manual for High Voltage Process Performance Motors
- 1
3BFP 000 063 R0101 REV D
Chapter 1 - Introduction
1.1 General information.................................................................................................... 1
1.2 Important note............................................................................................................. 1
1.3 Limitation of liability.................................................................................................. 2
1.4 Documentation............................................................................................................ 2
1.4.1 Documentation of the machine.................................................................. 2
1.4.2 Information not included in documentation............................................... 3
1.4.3 Units used in this User’s Manual............................................................... 3
1.5 Identification of the machine...................................................................................... 3
1.5.1 Serial number of the machine.................................................................... 3
1.5.2 Rating plate................................................................................................ 3
Chapter 2 - Transport and Unpacking
2.1 Protective measures prior to transport ........................................................................ 6
2.1.1 General....................................................................................................... 6
2.1.2 Bearing plate.............................................................................................. 7
2.2 Lifting the machine..................................................................................................... 7
2.2.1 Lifting a machine in a seaworthy package................................................. 8
2.2.2 Lifting a machine on a pallet ..................................................................... 9
2.2.3 Lifting an unpacked machine..................................................................... 9
2.3 Turning a vertically mounted machine ..................................................................... 10
2.4 Checks upon arrival and unpacking.......................................................................... 11
2.4.1 Check upon arrival................................................................................... 11
2.4.2 Check upon unpacking............................................................................. 11
2.5 Storage ...................................................................................................................... 11
2.5.1 Short term storage (less than 2 months)................................................... 11
2.5.2 Long term storage (more than 2 months)................................................. 12
2.5.3 Rolling bearings....................................................................................... 13
2.5.4 Openings.................................................................................................. 14
2.6 Inspections, records .................................................................................................. 14
Chapter 3 - Installation and Alignment
3.1 General...................................................................................................................... 15
3.2 Foundation design..................................................................................................... 15
3.2.1 General..................................................................................................... 15
3.2.2 Forces to the foundation .......................................................................... 16
3.2.3 Flanges for vertically mounted machines................................................ 16
3.3 Machine preparations before installation.................................................................. 16
3.3.1 Insulation resistance measurements......................................................... 16
3.3.2 Disassembly of the transport locking device........................................... 16
3.3.3 Coupling type........................................................................................... 17
3.3.4 Assembly of the coupling half................................................................. 17
3.3.4.1 Balancing of coupling....................................................... 17
3.3.4.2 Assembly........................................................................... 17
3.3.5 Belt drive.................................................................................................. 18
3.3.6 Drain plugs............................................................................................... 18
3.4 Installation on concrete foundation........................................................................... 18
3.4.1 Scope of delivery..................................................................................... 18
3.4.2 General preparations................................................................................ 18