AquaMaster 3
Electromagnetic flowmeter 2 Mechanical Installation
User Guide OI/FET2XX–EN Rev. E 15
2.4.3 Installing a SIM Card
Referring to Fig. 2.25:
1. Remove the transmitter from its mounting point.
2. Use water to wash off any loose dirt from the case and dry the area around the SIM cover.
3. On the back of the transmitter, unscrew and remove the cover
A protecting the SIM card holder
B.
4. If a SIM card is being changed, ensure the GSM Engine is off before removing the card by reading
>368 (see COI/FET2XX–EN) and the status reported in Off.
5. Carefully lift the right-hand edge of the holder
B outwards.
6. Slide the SIM card
C into the carrier, contact side down and bevelled edge to the top-right.
7. Close the holder
B until it clicks into place and refit the cover A.
8. SCrew cover
A firmly in place.
Fig. 2.25 Installing a SIM Card
To Next Page
Loading...
