AquaMaster 3
Electromagnetic flowmeter 3 Electrical Installation
18 User Guide OI/FET2XX–EN Rev. E
3.2 Connections
3.2.1 AquaMaster 3 Connections
Referring to Fig. 3.4:
1. Remove the screwed cap
A on the sensor connector.
2. Gently push the sensor plug
B into the socket and rotate it until it engages, then tighten the locking
ring.
Note. Refer to Section Fig. 3.4, page 25 for MODBUS connection.
Note. If the sensor cable is terminated with fly leads, connection is via a sensor cable adapter box (part
number WABC2035, available separately).
Fig. 3.4 Sensor Connections
To Next Page
Loading...
