ABB AquaMaster 3 - Display Activation; Display Information

AquaMaster 3
Electromagnetic flowmeter 4 Start-Up and Operation
32 User Guide OI/FET2XX–EN Rev. E
4.2 Display Activation
To activate the display during normal operation:
1. Cover the display area for a few seconds.
2. Uncover the display area. The display is activated and the AquaMaster 3 cycles through the
programmed set of display measurements.
4.3 Display Information
Note. To use local or remote serial communications, for instructions on how to alter the displayed set of
measurements and for meter setup, refer to COI/FET2XX–EN.
Fig. 4.1 AquaMaster 3 Display Information
kPa
AB
ML
1
2
Lower Display
Time
Flow Velocity
Pressure
Low Battery
Sensor Fault
Empty Pipe Condition
Mains Failure
Low GSM Radio Signal
Renewable Energy Not Present
Upper Display
Date
Forward Flow Total
Reverse Flow Total
Net Flow Total
Tar iff To ta l
Warning
Annunciators