41
5.2.3 Standard Controller
This section deals with the functionality which is specific of the standard controller.
5.2.3.1 Std Controller Display
The standard controller display shows the following values:
• Instantaneous value of process variable measure
• process variable temperature (not present for ORP sensor)
• set-point
• output signal value
• Controller status: A/M (A = Automatic, M = Manual).
Fields of display are configured as in the following draft:
Process measured value Process Temperature
1 2 . 5 2 p H 1 5 . 5 ° C
1 2 . 0 0 S P 1 6 % O U T A
Set-point Output (%) Automatic/Manual (A/M)
If the instrument is configured to perform additional functions beside operating as a controller, for example to
monitor another parameter with a second or third sensor installed on channel 2 or 3, the indication of these
values can be called on display by pressing the key END, which will cycle through the different displays
available, and eventually back to the controller display
To Next Page
Loading...
