ABB AW400 Series - Serial Link Signal Connection

60
10.3 Serial link signal connection
The AW400 optional serial communication P.C. Board is equipped with modular telephone RJ45 type jack
supporting both for RS 232 and RS 422/485 standards:
RJ45 TELEPHONE SIGNAL CONNECTION JACK LAY-OUT:
Pin N.
RS 232 RS 422 RS 485
1
GND
Ground
Tx +
Data transmission to PC, +
-
2
Rx IN
Data transmission from PC
Tx –
Data transmission to PC, -
-
3
Tx OUT
Data transmission to PC
GND
Ground
-
4
-
Rx +
Data transmission from PC, +
Data transmission to and from PC, -
5
-
Rx –
Data transmission from PC, -
-
6
GND
Ground
GND
Ground
Data transmission to and from PC, +
Table 13 - RJ45 Jack serial Communication connector pin-out
RJ45 Jack
Fig. 16 - RJ45 Connector layout
For RS232 and RS485 use shielded cables, two-cores twisted pair wire, section 0.5 ÷ 1.0 mm
2
.
For RS422 use shielded cable, 4 cores, twisted pairs wire, section 0.5 ÷ 1.0 mm
2
.
Connect shields to the ground shield terminal strip inside AW400.
1
6