ABB COMMANDER 300 - Introduction to Serial Communication; Preparation and Standard Settings; Company Standard Settings

2
2.1 Preparation for Changes to
the Parameters
Ensure that the external alarm/control
circuits are isolated if inadvertent
operation during programming is
undesirable.
Any change to the operating parameters
are implemented using the or
switches – see Section 3 of the Operating
Guide .
Note. The instrument responds
instantly to parameter changes which
are saved when the switch is
pressed.
2 GENERAL PROGRAMMING1 INTRODUCTION
The COMMANDER 300 Series of
documentation is shown in Fig. 1.1. The
Standard Manuals, including the specification
sheet, are supplied with all instruments. The
Modbus Supplement is supplied with
instruments configured for Modbus Serial
Communication.
The Installation manual includes an
Installation Record which should be
completed as a log of the electrical
installation. The record is useful when
carrying out initial instrument programming
and can be retained for future reference
PROGRAMMING
Part No.
IM/C300–PG
Basic Config. Level
Advanced Config.
Level
OPERATION
Setting Up
Displays & Controls
Operating Level
Simple Fault Finding
Part No.
IM/C300–OG
Part No. IM/C300–INS
or IM/C310–INS
INSTALLATION
Product Identification
Siting
Mounting
Electrical Connections
Installation Record
MODBUS (RTU).
Serial Adaptors
Serial Connections
Programming Page
Part No. IM/C300–MOD
or IM/C310–MOD
SPECIFICATION SHT.
Full Specification
Part No. SS C300
or SS C310
Modbus Registers
Standard Manuals Modbus Supplement
Fig. 1.1 Commander 300 Documentation