130
Service
3ADW000195R0501 DCS800 Service Manual e e
Connect the DCS800 directly with the PC, fiber optic cable from SDCS-COM-8
channel 3 to:
1. PCMCIA adapter NDPA-02 with NDPC-12 or
2. USB adapter RUSB-02
Switch on the DCS800
Set Ch3 HW Config (70.21) = Ring
Set Ch3 NodeAddr (70.22) = 1
Start firmware download by a double click on file L_AMC_DC.BAT:
A DOS window will appear. Wait until the download is finished (the DOS
window will close automatically)
Attention:
Do not touch the PC during the download of the firmware!
Check Com8SWVersion (4.11) for proper firmware version
Set Ch3 HW Config (70.21) back to its original setting
Set Ch3 NodeAddr (70.22) back to its original setting
Re-connect the drive to the DriveWindow network
To Next Page
Loading...
